EDDYTHERM microprocessor controlled Induction Heater for bearings and other objects allows precise setting of time or temperature to prevent premature bearing failures due to overheating. Temperature probe continuously measures and screen displays actual temperature. "Stand by" feature permits holding temperature at pre-set level for an indefinite time. Automatically demagnetizes workpieces after heating. Light and buzzer signal termination of heating/demagnetizing cycle. Three models available. Shrink-fitting bearings, sleeves, sprockets, couplings, impellers, crane wheels and gears, etc., of up to 880 lb. is made easy, clean and quick.

Benefits

• Reduce installation costs
• \Multiply bearing life Prevent bearing contamination and damage
• Prevent overheating of heat-sensitive parts
• Safe energy

Testing and Time Study Service

It is difficult to determine how long it takes to heat gears, impellers, couplings, bearings and other workpieces from ambient to the target temperature for proper shrink fitting. Theoretical calculations are not always reliable, since so many factors such as ID, OD, width, material, configuration of workpiece and weight come into play.

We offer you the services of our induction heater lab to conduct tests on your samples. This will guarantee that you can duplicate achieved and documented results in your facilities with the recommended heater and selected crossbars.